1. My rider crashes, the camera fades into blackness, and then switches to another camera where it slowly goes back to normal
Crash>splitter:
1. State trigger (on)>linear data source (unchecked), exposure (start 80, end 0)
2. Delayed Impulse>State trigger (on)>Linear data source (unchecked), exposure (start 0, end 80)
3. Delayed impulse> camera event connected to other camera
SO ALL OF THIS WORKS GREAT
But!
If I cross the finish line, I want the same thing to happen, just to another camera. So I'm a bit stuck on how to connect it to the same splitter, or a whole other trigger...since the game camera can only connect to one data source at a time.
please help)
u could make the cam you're using following the rider....and use cam on/off event to turn on/off the cam when (not) needed.
That way you can use that cam wich is connected to a data source.
Hope this helps..im sure somebody has an easier solution....but this is how i would do it.
https://www.youtube.com/watch?v=myMwjFxjzWw (evo but stil good)
trials fusion and evolution uses the same editor....the fusion editor is just more expanded
And because there is no Trials Fusion tutorial, i gave the one from trials evo.
Here is an livestream archive from all trials fusion editor livestream. https://www.youtube.com/playlist?lis...kcueIutC42ZmJx
But then how would the editor be able to switch the camera if the rider crashes compared to when you finish the track? And Yeah I know, I changed the cam exposure to 80. Thanks for your reply btw. If you want to check out what I have so far in terms of gameplay, then check out 'Elfen Lied cp7' in trials evolution, it should still be in new trials. Just crash and then you'll see what it is.Originally Posted by elCamsterino Go to original post
Ok I'll give that a go, I'm assuming I misunderstood what you meant originally.will get back to you
Edit: I played your track, nice look and very tough (couldn't finish it as i'm not great with ninja's) I watched your replay too
Do you want the camera to fade out at the end the way it does if you crash? Can't you tie 2 inputs to the state trigger if not the splitter?
Copy everything else in the chain again but use the original CDS. hope thats what your afterOriginally Posted by Camzarcar Go to original post
No worries dude... your the first person I've actually helped on here, it's normally me doing the askingOriginally Posted by Camzarcar Go to original post![]()