1. #1
    ZigZach420's Avatar Junior Member
    Join Date
    May 2010
    Location
    Cape Cod, Ma.
    Posts
    3

    Simple elevator help..

    Hello again Trials heads,
    I've been using the editor from Trials HD to Evo to Fusion, but since it's been awhile I'm having trouble setting up an elevator system..

    I want the rider to drive onto a platform and have it elevate upward using a slider joint, but I also need it to hit it's upper limit then lower to its original position. For some reason I can't seem to find a logical way to accomplish this, yet I really remember doing it must hilltops times in Evo! Ha ha.

    Any help or tips would be appreciated, thanks guys.
    Share this post

  2. #2
    You could tie the slider joint's motor speed to a variable data source, set the data source to a positive speed to make the elevator go up, then have an impulse delay that is long enough to allow it to get all the way to the top, then set the speed to negative so that it goes back down.
    Share this post

  3. #3
    ZigZach420's Avatar Junior Member
    Join Date
    May 2010
    Location
    Cape Cod, Ma.
    Posts
    3
    Heading back into the editor now I'll give that a try. Thanks alot Jorts!
    Share this post