Varying the custom cameras, during a fail? | Forums

[sparkierjonesz]

Vds?
I'm familiar with the set event..where it's just a specific number....that would filter off the camera, then back to the vds?

a variable datasource

if you crash the switch filter gets an impulse it checks the value of the vds and sends an impulse to the corresponding camera event that eventsend the impulse to the set event to change the number to the camera you want to activate next crash

[rlmergeuser]

You would would tie the switcher "comparison value" to variable data source. The variable data source would be set at 1 initially.
Then you're running the "set" icon which is set for 2 at the end of camera one. This would point back to the variable data source. Next time it triggers, it would run #2, and so on.
I like it.
Is this correct?

[sparkierjonesz]

yes

[rlmergeuser]

Thanks. I appreciate the help. I'm putting out a few Ninja Challenges shortly with the camera variations.
-VEGAS TRASH