Is it possible to disable lean temporarily? | Forums

[rlmergeuser]

I want to disable the ability to lean for a section in the middle of the track I'm making, but allow leaning before and after. Is there a way to do this with a trigger or event?

[rlmergeuser]

[rlmergeuser]

BAH, thank you very much I was literally on ep. 27 when i posted this.

I will finish the entire series before I post again.

[rlmergeuser]

Okay I was able to spawn disable left stick (left / right) to disable leaning, but I can't seem to tie it to a trigger. So how do I make it temporary rather than permanent?

[sipe]

Okay I was able to spawn disable left stick (left / right) to disable leaning, but I can't seem to tie it to a trigger. So how do I make it temporary rather than permanent?

Any checkbox, slider and value can be controlled with datasources. Press "Y" on any property and then select datasource from the track. Then you can dynamically change datasource value with set value event with triggers.

0 = unchecked, 1 = checked

0 = slider value 1
1 = slider value 2
2 = slider value 3 etc..

[rlmergeuser]

Okay I was able to spawn disable left stick (left / right) to disable leaning, but I can't seem to tie it to a trigger. So how do I make it temporary rather than permanent?

Any checkbox, slider and value can be controlled with datasources. Press "Y" on any property and then select datasource from the track. Then you can dynamically change datasource value with set value event with triggers.

0 = unchecked, 1 = checked

0 = slider value 1
1 = slider value 2
2 = slider value 3 etc..

Remember how I said I wouldn't ask any more questions until i finished the video series...yeah i lied (this was in video 28 I know see).

Alright I promise, no more questions until i finish all the videos.

However, in the pc version I am clicking the tiny square in the bottom right of properties to assign them to a data source. What is the button that corresponds to "Y" on the xbox. I thought it was shift, but apparently not.