Bug: Codes won't work when copied (sometimes) | Forums

[rlmergeuser]

I have only ran across this twice but I figured I should post it.

All your coding is visually connected and lined up however when you test it certain pulses dont go through. What I did in both cases was duplicated a group of coding. And what I did to fix it was unlink and relink the problem code. I do this alot and again its only happened twice so there might be more to how I trigger the bug but to my knowledge I only copied and past.

[Jarr3tt88]

This happened to me too and I couldn't figure out why....I just thought of another way to do what I needed to (Clean Sweep Minesweeper remake) It was baffling how same thing copied didn't work the same.

Then I tried to recreate it manually, and that wouldn't work either.

[sparkierjonesz]

make sure everything is well conected and triggered and enabled

the values in the event might change but that doesn't mean it works already if it isn't triggered it wont do what its supposed to do

make sure everything that needs it is conected by a red line and that it turns brighter when you test it
if it doesn't turn brighter something is wrong in the chain of previous triggers and events

also when you copy things not all conections get copied

else you need to post a picture here or let someone else try to recreate it