1. #1
    Hi,

    I'm trying to build a df map where there are moving vehicles but I want some of them to only start after a set time. I've set the delay in the 'time out' boxes in FMB but when the mission starts all the vehicles are moving.

    Any ideas?

    Thanks!
    Share this post

  2. #2
    Aviar's Avatar Senior Member
    Join Date
    Nov 2001
    Posts
    1,488
    The TimeOut setting is defined as 'XX:XX' (Hours:Minutes). The first waypoint basically does nothing. So, what you should do is place the first two waypoints as close as possible and use the TimeOut setting you prefer on the first TWO waypoints (Waypoint 0 and 1).

    When the vehicle reaches Waypoint 1, it will stay there for as long as you set the TimeOut.

    Aviar
    Share this post

  3. #3
    Ok, thanks Aviar!
    Share this post

  4. #4
    Aviar's Avatar Senior Member
    Join Date
    Nov 2001
    Posts
    1,488
    Check my first post again. I edited the info slightly.

    Aviar
    Share this post

  5. #5
    Got it!
    Share this post