🛈 Announcement
Greetings! The Division forums are now archived and accessible in read-only mode, please go to the new platform to discuss the game
  1. #1
    ProdigualSon's Avatar Junior Member
    Join Date
    Jan 2015
    Location
    UK
    Posts
    4

    ManHunt Issue - Can't progress

    Hi,

    Playing ManHunt (Termite Enemy). We have to complete 3 Control Points, 2 Bounties and 1 Mission (Federal Emergency Bunker) to discover where Termite is and kill him.

    However, I'm stuck cause all the Control Points are green in the West End, but as you can see on the screenshot (on the right-hand side), it says I have only completed 2 out of 3 Control Points!!!
    Does anybody else have this issue? Is it a bug?

    thanks

    Share this post

  2. #2
    Ubi-Mark.'s Avatar Ubisoft Support Staff
    Join Date
    Nov 2017
    Location
    Base of Operation
    Posts
    6,899
    Hello ProdigualSon,

    Thanks for reaching out! Can you please press the button responsible for your Global Settings to change your Global difficulty? It will reset your control points. Just to clarify, this is not a bug. If you captured these control points already, you can reset them manually.

    I hope it helps and if you have any additional questions, please let us know.
    Share this post

  3. #3
    ProdigualSon's Avatar Junior Member
    Join Date
    Jan 2015
    Location
    UK
    Posts
    4
    Thanks @ubi-Mark for your reply.

    Quick questions please:
    1. If I change my Global Difficulty from Normal to Hard for instance, will it reset ALL of my Control Points on the map?? That means I'd have to re do all of them again?
    2. Can I just change Global Difficulty from Normal to Hard and then immediately back from Hard to Normal or will I have to re do all Control Points in the new Global Difficulty?
    3. You say I can reset Control Points, can I reset only the one I want or just all of them? Also, when you say "reset", you're talking about the same workaround (change Global Difficulty), correct? Or is it another way to reset a Control Point?

    Thank you so much
    Share this post