-
Member
PSA: Calibrate your Controllers
Just a headsup: After struggling to finish "Don't release gas" contracts I wondered why the game thought I was off the gas even though my trigger still had a good portion of travel left. Then it occured to me, that it might be a controller issue. Search for " joy.cpl" in the search bar. Select your controller and go on properties, for my 360 controller it should show 3 even bars for the axis and rotation settings, they were off by a bit.
If that's the case for your controller aswell you can then go into the settings tab and then calibrate.
Throttle control is so much better for me now, thought it might help some other players aswell.
-
Member
Thanks for the tip.
I encountered a similar issue going back to Fusion on PS4 the other day. I started an Extreme and the Pit Viper seemed really sluggish. It turned out my old controller apparently wasn't registering 100% gas on the RT, although it was functioning well enough for other games. I switched to a newer controller and it was fine.
-
Member
Hi K0libree, Dont know if u bought the game via steam but u can also use the Big picture mode to config ure controller better than bog standard windows can - if u didn't buy via steam im sure u could get a wrapper that'll do the jobs for u too 
https://www.howtogeek.com/234427/how...am-controller/
-
Community Representative
Hello K0libree,
Thanks for sharing this helpful tip with other riders!
-
Member
I just tape my right trigger down so it barely registers as an input and then I use A to accelerate