1. #1

    Help with decals

    Can anyone tell me if there is a way to change the Alpha of decals with the increase/decrase values or data sources, to make them fade in and out. I know theres a way to change the 'brightness' slider on the primes, and figure the method would be pretty much the same, but, I've forgotten how to do it.

    Also, bonus question, with audio turned off on bike and rider, I still get the 'put put put' of the exhaust, any way to cut that out too, or is it something we can't change?
    Share this post

  2. #2
    Hey.

    You can do this by tying the color value to a Curved Vector Data Source. Then have two vectors for your end and start vector. Change the vector size slider in the vector to 4. Now value x,y,z is for RGB values and value W is for alpha. Alpha also goes from 0-255.
     1 people found this helpful
    Share this post

  3. #3
    Thank you so much. That is going to come in very handy, I'd started to assume it wasn't possible.
     1 people found this helpful
    Share this post