I checked out your screenshots and videos, and it was very helpful. I got everything set the way you had it in the video and it still wasn't working, but I was able to figure out what I was doing wrong and you will probably get a good laugh... I had my physics event disabled assuming that the pulse from the area trigger was going to enable it which would then turn the physics on for the ramp. Oddly, with it disabled, the pulse still somehow made it from the area trigger, through the physics event, through the set value event, and into the variable data source. I could see the variable data source change to 1.00 in the editor. But apparently, despite all of that working, having the physics event disabled did not allow the physics on the ramp to be turned on. I assumed that enabling it would make it trigger the physics immediately, and not from the area trigger. Anyway, once I enabled that, all seems to be working... Now to go apply this to the track I'm working on. Thanks to everyone who posted here for the help!