Originally Posted by dasraiser
hi
2. yes
use one interval trigger to control a variable data source that's controlling the main interval triggers interval.
set up for your main interval
need 1xVariable Data Source (VDS) with its value set to 30 (0.5sec, if this is what you need for your interval)
your main Interval Trigger settings:-
Start Delay=30, this sets when its 1st impulse is sent out
Interval = Select your VDS
second control Interval Trigger
Start Delay=3600 (1 minute)
Interval=1
check Disable after N ticks and set the value to 1
point the select filter/event to a Set Value Event , settings for Set Value Event:-
Target=VDS
Type:Set
Value=15 = 0.25 sec
and that should do it
3.
you need 1xVDS set value to 0
Interval Trigger
settings for the Interval Trigger:-
uncheck Enabled and use a State Event set to On targeting this to enable the effect when you need it
start delay =0
interval=1
disable after N=1 tick
select filter/event targeting a 'set value event' (SVE), its settings :-
Set, target VDS, value =5
select filter/event to a delay filter, its settings:-
delay=30, select filter/event to another SVE this time set it up to reset the VDS back to 0
now open the sound source and on the pitch settings choose the VDS as its target.