PDA

View Full Version : Object position event problem



rlmergeuser
04-23-2012, 07:46 PM
I have an object position event that works perfectly I am then trying to get it to trigger another object position event so the object with turn a corner but all it does is snaps the object to the finishing point of the 2nd object position event.
Any help would be great http://forum.redlynx.com/forum/images/smilies/icon/smile.gif

rlmergeuser
05-02-2012, 09:25 PM
Try connecting a state event to your second object position event's curved data source and make an area trigger so that when the object enters it the state event turns the curved data sources on and the second event takes over. Make sure the first event isn't set to loop and if there are any checkpoints within this whole event, make sure reset in checkpoint isn't checked. I hope this works.