View Full Version : Rotary elevator trim question

03-22-2006, 12:35 PM
I have my elevator trim on my rotary on my x-45 throttle, currently i believe it is 100 across the board and when i use it it is very sensetive to the elevators. Can i tone down this in the config when i find the corresponding line so its not so sensetive, i never had messed with this before only my pitch,yaw,roll settings. Any one have a good setting for the elevator trim for the rotary knob. Thanks all

03-22-2006, 01:46 PM
Try this utility it allows you to change HOTAS setting. You can get it from Airwarfare.

IL-2 Stick Sensitivity Tool (http://www.airwarfare.com/Sims/FB/fb_essential_files.htm#087)

03-22-2006, 02:39 PM
Im using the smallest of Olegs Curves for mine(tho its still pretty sensitive)The top one is my rudder trim which I got the curve from knightfly, the bottom is my Elevator trim(This is on an X-52)

1RX=0 6 12 28 45 55 65 75 85 95 100 10
1RY=0 1 4 9 15 24 35 48 64 80 99 10

May wanna have a look at This Thread (http://forums.ubi.com/eve/forums/a/tpc/f/49310655/m/5241008224)I may give Daimon's curves a try as Im always looking for "the Sweet Spot" to get nice smooth Elevator adjustments(the rudder setting Im am currently using is fairly smooth to use)