PDA

View Full Version : CampaignAI=?



foxyboy1964
10-26-2005, 03:29 AM
I want to tweak my campaigns to make them easier. I read Dieg777's guide at Airwarfare but I'm not sure if I should set the AI to Easy or Low. Anyone know?

foxyboy1964
10-26-2005, 03:29 AM
I want to tweak my campaigns to make them easier. I read Dieg777's guide at Airwarfare but I'm not sure if I should set the AI to Easy or Low. Anyone know?

dieg777
10-26-2005, 05:08 AM
remember to add [dgen] section to your config then add these lines

CampaignMissions=easy

Settings are easy, normal or hard. Default or not having the line in conf.ini is normal. This changes the scripts ( ops files, I.E. - ops41-E.dat, where "E", means easy ) files in the Dgen folder used to generate missions. Affects the number of enemy planes encoutered as opposed to the number of friendly planes in your group/s. For example, set on easy, you might have a mission generated which gives you four fighters on your side with four bombers, and two enemy fighters will later show up to intercept your bombers. The very same mission on hard might give you only two fighters on your side, maybe the same number of bombers to escort, but you'll run into four enemy fighters to deal with!! This balances out so it does not affect frame rate much, if at all.

CampaignAI=easy

Settings are easy, normal or hard. Default or not having the line in conf.ini is normal. Increases enemy and friendly AI by a factor of one. Low increases friendly AI level higher while lowering enemy AI level. High does the opposite. Normal gives you a more even match of AI strength."

So for you set both to easy

good luck

foxyboy1964
11-02-2005, 09:33 AM
Belated thanks Dieg777 http://forums.ubi.com/images/smilies/25.gif