PDA

View Full Version : ME 262 Taxi Difficulty + Land/Take off



stanner1935
01-03-2005, 04:45 PM
I find it impossible to taxi in the ME 262, since I cannot turn the aircraft. Is there a specifi technique applicable to taxinig the ME 262?

What is the suggested take off speed?
On takeoff, what is suggested rudder trim?
What is the suggested landing speed?
Any rudder trim necessary when landing?

Thanks

stanner1935
01-03-2005, 04:45 PM
I find it impossible to taxi in the ME 262, since I cannot turn the aircraft. Is there a specifi technique applicable to taxinig the ME 262?

What is the suggested take off speed?
On takeoff, what is suggested rudder trim?
What is the suggested landing speed?
Any rudder trim necessary when landing?

Thanks

Von_Zero
01-03-2005, 08:51 PM
Dunno about the trim required but the game manual states the following:
TakeOff speed: 195km/h
Landing speed: 180km/h

About taxiing:
method 1: turn the rudder in the direction you want to turn, hold the brakes (i think B is the default key) and push the throttle as required.
method 2: increase the RPM of the engine from the opposite side (if you want to turn right increase the rpm of the left engine, or the other way around) (this can be associated with some amount of brakes)

billy885
01-03-2005, 09:53 PM
What I do to taxi jets:

Slowly increase throttle to about 30% then use brakes and rudder to control speed and directions. Yes the B key is the default brakes. When you get close to where you want to be slowly lower throttle to about 10%, is lower most of the time a motor will flame out.

Good luck.

stanner1935
01-03-2005, 10:05 PM
Thank you.