PDA

View Full Version : Hows Rudder input on a X45 with 4.0....???



Charlie901
06-12-2005, 03:47 PM
Do I need to get pedals or am I going to be o.k. here, with my trusty rocker switch?

Also is it best to have rudder and aileron trim still, on the rotaries?

Thanks http://forums.ubi.com/images/smilies/25.gif

Charlie901
06-12-2005, 03:47 PM
Do I need to get pedals or am I going to be o.k. here, with my trusty rocker switch?

Also is it best to have rudder and aileron trim still, on the rotaries?

Thanks http://forums.ubi.com/images/smilies/25.gif

ROTS_Jason
06-12-2005, 04:57 PM
I have an X45 and I couldnt get my **** mustang off the ground! I had to turn down the sensitivity on my rocker rudder quite a bit. Works fine now... think its gonna take a little getting used to though!

Freelancer-1
06-12-2005, 05:05 PM
The rudder rocker is good for anything BUT rudder control. Get some pedals or map a rotary to rudder.

Freelancer

Maj_Death
06-12-2005, 05:39 PM
Works fine for me. But you absolutely must properly trim planes now for them to be controllable.

Tallyho1961
06-12-2005, 08:02 PM
I dialed down my rudder axis settings somewhat due to the finer degree of control now required, but other than that A-OK. No problems on takeoff - add throttle slowly and correct for adverse yaw as your speed builds up - but lots more to think about once the wheels are up.

Much more fun to fly http://forums.ubi.com/groupee_common/emoticons/icon_smile.gif

Charlie901
06-13-2005, 11:03 AM
O.K. Thanks http://forums.ubi.com/groupee_common/emoticons/icon_smile.gif

How do you turn down the rocker settings?

What input axis is it covered under and what were the best reduced settings?

Or did you all change it under the config file?